Redis 中spark参数executor-cores引起的异常解决办法

报错信息

Unexpected end of stream

16/10/11 16:35:50 WARN TaskSetManager: Lost task 63.0 in stage 3.0 (TID 212, gzns-arch-spark04.gzns.iwm.name): redis.clients.jedis.exceptions.JedisConnectionException: Unexpected end of stream.
 at redis.clients.util.RedisInputStream.ensureFill(RedisInputStream.java:199)
 at redis.clients.util.RedisInputStream.readByte(RedisInputStream.java:40)
 at redis.clients.jedis.Protocol.process(Protocol.java:151)
 at redis.clients.jedis.Protocol.read(Protocol.java:215)
 at redis.clients.jedis.Connection.readProtocolWithCheckingBroken(Connection.java:340)
 at redis.clients.jedis.Connection.getBinaryMultiBulkReply(Connection.java:276)
 at redis.clients.jedis.Connection.getMultiBulkReply(Connection.java:269)
 at redis.clients.jedis.Jedis.hmget(Jedis.java:723)

DENIED Redis is running in protected mode because protected mode is enabled

DENIED Redis is running in protected mode because protected mode is enabled,
 no bind address was specified, no authentication password is requested to clients.
 In this mode connections are only accepted from the loopback interface. 
If you want to connect from external computers to Redis you may adopt one of 
the following solutions: 1) Just disable protected mode sending the command
 'CONFIG SET protected-mode no' from the loopback interface by connecting to
 Redis from the same host the server is running, however MAKE SURE Redis is not 
publicly accessible from internet if you do so. Use CONFIG REWRITE to make this change
 permanent.
 2) Alternatively you can just disable the protected mode by editing the 
Redis configuration file, and setting the protected mode option to 'no', 
and then restarting the server. 3) If you started the server manually just 
for testing, restart it with the '--protected-mode no' option. 4) Setup a bind 
address or an authentication password. NOTE: You only need to do one of the above 
things in order for the server to start accepting connections from the outside.
 at redis.clients.jedis.Protocol.processError(Protocol.java:127)
 at redis.clients.jedis.Protocol.process(Protocol.java:161)
 at redis.clients.jedis.Protocol.read(Protocol.java:215)

解决过程

我尝试重启redis,更换redis新jar包,关闭redis保护模式都于事无补,后来找了下错误的原因,无意中看到了Unexpected end of stream是说有一个进程占用了redis的链接,头脑一炸,才发现自己把executor-cores设置为了2,然后把该值设置为1后,正常了。

看来只有等接入redis集群后,我才能修改该值了。

感谢阅读,希望能帮助到大家,谢谢大家对本站的支持!

标签:
Redis,spark参数executor-cores异常,spark参数executor-cores引起的异常

免责声明:本站文章均来自网站采集或用户投稿,网站不提供任何软件下载或自行开发的软件! 如有用户或公司发现本站内容信息存在侵权行为,请邮件告知! 858582#qq.com
内蒙古资源网 Copyright www.nmgbbs.com

RTX 5090要首发 性能要翻倍!三星展示GDDR7显存

三星在GTC上展示了专为下一代游戏GPU设计的GDDR7内存。

首次推出的GDDR7内存模块密度为16GB,每个模块容量为2GB。其速度预设为32 Gbps(PAM3),但也可以降至28 Gbps,以提高产量和初始阶段的整体性能和成本效益。

据三星表示,GDDR7内存的能效将提高20%,同时工作电压仅为1.1V,低于标准的1.2V。通过采用更新的封装材料和优化的电路设计,使得在高速运行时的发热量降低,GDDR7的热阻比GDDR6降低了70%。